LaserCAD does not bind to correct network interface

LaserCAD using the network interface is a great way to communicate with your laser cutter. Unfortunately the program seems to choose the wrong interface card on my desktop and there appears to be no way to change this besides disabling all other network adapters and running the program again.

  1. Download the Zip file install from above location
  2. Extract to exe location you want to switch the interface of
  3. Create shortcut to the program EXE with these commands: ForceBindIP “C:\LaserCAD\AWCPrograms\LaserCAD.exe”  – Note to replace the IP and paths with your correct paths. 


Adding additional fonts to LaserCAD:



Leave a Reply

Your email address will not be published.