2 thoughts on “Anycubic Delta Printer – Smoothie board Settings

  1. Hi, Chester.

    I have an Anycubic Delta also, and I am contemplating changing the firmware to a newer version of Marlin, or replacing the stock TriGorilla board with either a Duet or a SmoothieBoard.

    Have you run G29 (bed leveling) and G33 (delta calibration) using the SmoothieBoard yet?

    What does your M503 report look like?

    Sean

  2. Hi Sean,

    Honestly I have not used this printer since last summer.. I need to find the time to finish my improvements to it but that hasn’t happened yet..

    The Duet looks like a good option but I have not purchased one yet myself.

    Chester

Leave a Reply to Sean Rhinehart Cancel reply

Your email address will not be published.