Anycubic Delta Printer – Smoothie board Settings

Here are my config files – this printer still needs to have the rails straightened some as It is not printing perfectly accurately.. But if you just want the basic config settings they are all applicable.


2 comments for “Anycubic Delta Printer – Smoothie board Settings

  1. Sean Rhinehart
    2018-07-24 at 7:26 pm

    Hi, Chester.

    I have an Anycubic Delta also, and I am contemplating changing the firmware to a newer version of Marlin, or replacing the stock TriGorilla board with either a Duet or a SmoothieBoard.

    Have you run G29 (bed leveling) and G33 (delta calibration) using the SmoothieBoard yet?

    What does your M503 report look like?


  2. 2018-08-13 at 9:47 am

    Hi Sean,

    Honestly I have not used this printer since last summer.. I need to find the time to finish my improvements to it but that hasn’t happened yet..

    The Duet looks like a good option but I have not purchased one yet myself.


Leave a Reply to Chester Lowrey Cancel reply

%d bloggers like this: